Engine Assembly Order
The following assembly for Flint and Tonawanda engine plants is general in nature as small variations were usually made from year to year.
Flint | Tonawanda |
Raw castings enter plant | Raw castings received from other parts of Tonawanda engine plant |
Block machining (broaching) in 1 to 2 days | Block washed |
Block begins upside down. Bore sizes on oil pan rail broadcast ahead to piston hook up area. | Oil galley plugs |
Galley plugs | Transmission alignment pins |
Camshaft | Camshaft |
Main bearing caps removed, crank installed, caps reinstalled. | Main bearing caps removed, crank installed, caps reinstalled. |
Flywheel & pressure plate | Flywheel & pressure plate |
Cam & crankshaft gears, timing chain | Cam & crankshaft gears, timing chain |
Piston installation | Piston installation |
Front engine cover and seal | Front engine cover and seal |
Harmonic balancer | Harmonic balancer |
Oil pump shaft and oil pump | Oil pump shaft and oil pump |
Windage tray bolts if applicable | Windage tray bolts if applicable |
Oil pan and hardware | Oil pan and hardware |
Clutch housing | TDC determined, timing pointer |
Engine turned upright | Engine turned upright |
TDC determined, timing pointer | Cam & lifters |
Cam & lifters | Build date/suffix code stamped * |
Cylinder heads installed | Cylinder heads installed |
Rocker arms studs, arms, & balls installed | Rocker arms & balls installed (studs already installed) |
Intake manifold installed | Valves adjusted |
Valves adjusted | Intake manifold installed |
Valve covers installed | Water outlet & thermostat installed |
Miscellaneous brackets and switches installed | Water pump installed |
Build date/suffix code stamped | Spark plugs installed |
Water test with vacuum gauge | Distributor installed |
Oil cavity test | Miscellaneous brackets installed |
Paint assembly | Exhaust manifolds |
Distributor installed | Vacuum test |
Coil & plug wires | Valve covers |
Spark plugs | Paint assembly |
Temperature switches | Hot test |
Water and oil drained | Water and oil drained |
Exhaust manifolds installed | Racked & readied for shipment |
Spark plug wire supports, heat shields, other miscellaneous brackets installed. | |
Component verification | |
Racked & readied for shipment |
* Early (1965) big block engines were stamped further to the right on the engine pad due to the large plug in the end of the cylinder head after assembly at Tonawanda. This caused problems for the final assembly plants in stamping the partial VIN identification. Later the engine ID information was stamped on the left of the pad before the heads were installed allowing the right side of the engine pad to be used for the car's partial VIN to be stamped.